OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C06

A Camshaft Profile Actuator Position Sensor A Range/Performance Bank 1

P2C06 deals with a feedback signal that is electrically intact but makes no sense. On GM's 2.7 L L3B, the ECM follows each shift of the intake profile actuator A on bank 1 through three Hall feedback states: extending once the reading falls below 55, extended below 45 and retracted, back at home, above 68. The code is logged when these states do not appear as expected after a command, or when the feedback reports pin movement although no shift was requested. It needs 4 faulty readings out of 5 with the engine running, supply above 11 V and no crank or camshaft sensor faults, and it is a Type A fault (19OBDG03D, 25OBDG03B). CARB names a single pin that fails to move as a failure the lift monitor must cover. A sticking actuator is more likely than wiring here.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 06

Possible causes

  • Actuator pin sticking or slow because of wear or dirty oil high
  • Worn groove or sliding sleeve on the intake camshaft medium
  • Hall feedback element in the actuator giving wrong values low

Symptoms

  • Check engine light on immediately
  • Lift switching disabled, engine stays on one cam profile
  • Possible ticking noise from the cylinder head

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C06

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication