P2C05
A Camshaft Profile Actuator Position Sensor A Circuit Bank 1
Engines with switchable cam lobes use small solenoid actuators that push a pin into a groove of a sliding cam sleeve; a feedback signal confirms that the pin has moved. P2C05 is the general circuit fault for feedback A on the intake camshaft (camshaft A) of bank 1. GM uses it on the 2.7 L turbo four L3B in the Silverado and Sierra 1500 from 2019: in tables 19OBDG03D and 25OBDG03B the ECM tests the circuit while the output is energised and reports an open circuit at 200 kilohms or more between signal and ground in 4 of 5 samples, with supply above 11 V, as Type A with MIL on the first trip. Low and High are P2C07 and P2C08. GM bulletins PIT5677 and 21-NA-149 trace such codes on the L3B to engine harness chafing and blown fuses. Lift changes are locked out.
Possible causes
- Engine harness chafed, sometimes with blown fuses (GM L3B bulletins) high
- Loose or corroded connector at the profile actuator medium
- Open circuit inside the actuator or its feedback element medium
Symptoms
- Check engine light on immediately
- Cam lift switching and cylinder deactivation unavailable, slightly reduced power or economy
- With harness damage, many other codes and possibly no start
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C05
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.