P2C03
Fuel Pressure Regulator D Control Circuit Low
P2C03 is set when the switched low side of the regulator D control circuit has contact with ground. GM documents it in 23OBDG07 and 24OBDG07 for the second fuel quantity control valve, where it mirrors P0091 of the first valve. With the driver off, a healthy circuit shows a voltage on this line; if it is pulled low, the ECM concludes that less than about 0.5 ohm separates the pin from ground. The check needs more than 10.9 V supply and an engine speed above 80 rpm and counts 20 events before reporting, on the first trip. A short at the supply end of the same driver is a different GM code (P3138), so the code already tells which wire to inspect: typically the low-side lead chafed against the engine or a damaged valve connector.
Possible causes
- Low-side wire chafed through to ground high
- Damaged or wet valve connector medium
- Internal short in the quantity control valve low
Symptoms
- Check engine light on
- Reduced engine power
- Rough running at high load
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C03
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.