P2C02
Fuel Pressure Regulator D Control Circuit/Open
P2C02 is the open-circuit check on the control line of fuel pressure regulator D. In GM's tables 23OBDG07 and 24OBDG07 this is the second fuel quantity control valve of the high-pressure system, the twin of the valve watched by P0090. While the driver is switched off, the ECM expects a defined voltage on the line; if it reads low, it treats the load as disconnected, which corresponds to more than 200 kilohms between the ECU pin and the valve. Battery voltage must exceed 10.9 V and the engine must turn faster than 80 rpm, and the fault has to persist for 20 seconds. GM rates it as a one-trip fault. A broken wire, a corroded plug at the pump or an open valve coil are the usual causes; the affected pump can no longer be regulated.
Possible causes
- Broken wire or loose terminal in the valve circuit high
- Corroded or unplugged connector at the high-pressure pump medium
- Open coil in the quantity control valve medium
Symptoms
- Check engine light on
- Power reduction because one pump is no longer controlled
- Possible rail pressure fault codes alongside
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C02
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.