OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C01

Fuel Pressure Regulator D Performance

GM uses P2C01 in its 2023 and 2024 summary tables 23OBDG07 and 24OBDG07 for an engine control module that drives two fuel quantity control valves on the high-pressure side: P0089 covers the first, P2C01 the second, labelled regulator D. The ECM compares the filtered output of the high-pressure controller with fixed bounds. If it stays above 7.5 MPa for 10 seconds, the pump cannot reach the target even at full demand; a shorter 6 second path applies when the tank is empty or on reserve. Below minus 7.5 MPa for 10 seconds means pressure stays too high despite maximum reduction. Both require two trips. Wiring faults of the same valve are separate codes, P2C02 to P2C04. Drivers usually notice a lack of power, hard starting or the MIL after the second trip.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 01

Possible causes

  • Second high-pressure pump or its quantity control valve worn or sticking medium
  • Low tank level or weak low-pressure supply medium
  • Rail pressure sensor reading implausibly low

Symptoms

  • Check engine light on after two trips
  • Reduced power or stumbling at full load
  • Hard or slow starting

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C01

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication