P2BFF
Exhaust Flow Control Valve B Position Circuit High
P2BFF is the upper limit fault for the position feedback of exhaust flap B. An analog signal pinned near supply voltage, or a PWM feedback stuck near 100 percent, usually comes from a lost sensor ground, a signal wire touching voltage, or water bridging the connector pins. No manufacturer documents P2BFF publicly. Deutz uses the valve A counterpart P2BF7 when its flap voltage is too high, and GM's 23OBDG07 tables fail the second exhaust valve feedback above 98 percent duty cycle after 4 seconds, two trips to the MIL, under a GM-specific code. CARB asks for range checks on inputs of this kind. Unlike P2BFA, which concerns the drive line, this code points at the return signal, so the flap may still move while the computer no longer trusts the reported angle.
Possible causes
- Open ground at the flap B position sensor high
- Water or salt bridging the actuator B connector pins medium
- Signal wire shorted to a voltage source medium
Symptoms
- Check engine light on
- Exhaust mode warning, flap B held in default position
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BFF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.