OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BFE

Exhaust Flow Control Valve B Position Circuit Low

The position feedback of exhaust flap B reads below its lowest valid value. For an analog sensor that means a signal at or near 0 V, typically a short to ground or a missing 5 V supply; for a PWM feedback it means a duty cycle stuck near zero. No manufacturer publishes P2BFE. The nearest documented cases concern valve A: Mazda stores P2BF6 for a low shutter valve position signal and Deutz for a flap voltage below normal. GM watches the second valve of its 23OBDG07 application under its own code, failing below 2 percent duty cycle for 4 seconds. CARB requires such out-of-range checks. Because the two flap sensors often share a supply, a low reading on both sides at once suggests the common reference circuit rather than sensor B; a low on B alone points to its own wiring.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / FE

Possible causes

  • Flap B signal wire shorted to ground high
  • Sensor reference supply open or shorted medium
  • Position sensor in actuator B failed low

Symptoms

  • Check engine light on
  • Flap B no longer adjusted, exhaust sound unchanged

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BFE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication