OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BF6

Exhaust Flow Control Valve A Position Circuit Low

P2BF6 means the position feedback of exhaust valve A sits below its valid range, as with a signal shorted to ground or a lost sensor supply. Mazda is the best documented user: its 2.5 litre Skyactiv-G with cylinder deactivation carries an exhaust shutter valve that Mazda patents describe as closing partly in two-cylinder mode to damp exhaust pulsation noise. Bulletin 01-004/20 calls P2BF6:00 a shutter valve position sensor low input detected within one drive cycle and reports the master warning light plus reduced power on 2019-2020 Mazda3 and 2020 CX-30; the cause was faulty PCM logic, cured by reprogramming. Mexican-market cars without deactivation are excluded. Deutz uses the same code on MD1 engines when the flap voltage drops under its normal band. Wiring and sensor must still be checked.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / F6

Possible causes

  • PCM software misjudging the sensor (Mazda bulletin 01-004/20) high
  • Position signal wire shorted to ground medium
  • Sensor supply open or connector not latched medium
  • Position sensor in the shutter valve failed low

Symptoms

  • Master warning or check engine light on
  • Reduced engine power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BF6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication