P2BF3
Fuel Control System B Too Rich Bank 2
The last of the eight mode-specific trim codes: bank 2 is too rich while the port injectors (Ford fuel system B) are active. Ford triggers it when long-term trim has gone below minus 25 percent and short-term trim continues to subtract over 1 percent for 2 seconds, with the engine warm and purge disabled. Its value lies in what it excludes: a rich fault visible only in PFI mode and only on bank 2 rules out the canister, the high-pressure side and anything shared by both banks. That leaves a port injector on bank 2 that does not close cleanly, or a bank 2 upstream oxygen sensor that reads lean and drives the mixture rich. Ford includes P2BF3 in bulletins 20-2324, 20-2257, 21-2045 and 22-2393, covering F-150 trucks with either the 2.7 L EcoBoost or the 5.0 L engine.
Possible causes
- Port injector on bank 2 not sealing medium
- PCM software, Ford reprogramming bulletins medium
- Bank 2 upstream oxygen sensor biased lean low
Symptoms
- Check engine light on
- Fuel smell at idle
- Higher consumption
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BF3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- fordservicecontent.com/Ford_Content/catalog/motorcraft/OBD-Operations-Summary-Gasoline-2020-2023.pdf
- static.nhtsa.gov/odi/tsbs/2020/MC-10180534-0001.pdf
- static.nhtsa.gov/odi/tsbs/2021/MC-10187882-0001.pdf
- static.nhtsa.gov/odi/tsbs/2022/MC-10225455-0001.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2