OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BF0

Fuel Control System B Too Lean Bank 1

Fuel system B is, in Ford's monitor documents, the port fuel injection mode of engines that also have direct injectors. P2BF0 therefore means bank 1 runs lean only when the port injectors do the work. The decision rule matches the DI codes: long-term trim past plus 25 percent, short-term trim past plus 1 percent, held for 2 seconds during closed-loop operation with purge off. The suspects differ, though. Port injectors are fed by the low-pressure side, so a weak in-tank pump or low supply pressure, a clogged port injector or air entering past a port injector O-ring or intake gasket fit better than a high-pressure fault. Ford ships port injector O-rings with the 2.7 L injector repair in bulletin 20-2324 and lists P2BF0 in its reflash bulletins 20-2257, 21-2045 and 22-2393.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / F0

Possible causes

  • Low-pressure fuel pump or supply pressure too weak for the port injectors medium
  • Port injector on bank 1 clogged medium
  • Air leak at a port injector O-ring or intake manifold gasket medium
  • PCM software, Ford reprogramming bulletins medium

Symptoms

  • Check engine light on
  • Uneven idle or surging at light load
  • Hesitation when pulling away

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BF0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication