P2BEF
Fuel Control System A Too Rich Bank 2
P2BEF says that the engine module has had to take away a lot of fuel on bank 2 while direct injection alone was supplying the cylinders. Ford sets it on port-plus-direct engines when long-term trim on that bank drops past minus 25 percent while short-term trim keeps subtracting more than 1 percent; two seconds in closed loop are enough. Because the common rich fault P0175 is reserved for enrichment seen in every mode, P2BEF points at the DI hardware of bank 2: a direct injector that sticks open or seeps after shutdown, or a rail pressure reading that is too low so the pump overshoots. On 2019 and 2020 F-150 2.7 L EcoBoost trucks built until 4 July 2020, Ford bulletins 20-2257 and 21-2045 cure this code, together with the other fuel-trim codes, by reprogramming the PCM.
Possible causes
- Known PCM software issue on 2019-2020 F-150 2.7 L high
- Direct injector on bank 2 sticking open or seeping medium
- Rail pressure sensor reading too low, pressure actually too high low
Symptoms
- Check engine light on
- Rough running after a hot restart
- Increased fuel use
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BEF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.