P2BEE
Fuel Control System A Too Lean Bank 2
Here the lean correction concerns bank 2, the cylinder row without cylinder 1, and again only the direct-injection operating mode (fuel system A in Ford terms). Ford applies the same monitor as on bank 1: closed loop, warm engine, purge off, long-term trim above plus 25 percent combined with short-term trim above plus 1 percent for 2 seconds. Comparing banks narrows the search. If only P2BEE is stored, look at components that serve bank 2 alone, such as its direct injectors or its upstream oxygen sensor; if P2BEC appears as well, a shared item like the high-pressure pump or rail pressure sensor is more likely. Ford lists P2BEE in bulletins 20-2324 (2018 F-150 2.7 L) and 22-2393 (2019 to 2021 F-150 5.0 L, reflash and keep-alive memory reset).
Possible causes
- Direct injectors on bank 2 restricted medium
- PCM software requiring a Ford update medium
- Bank 2 upstream oxygen sensor reading skewed low
- Low rail pressure, usually with P2BEC on bank 1 too low
Symptoms
- Check engine light on
- Slight hesitation under load
- Often no other complaint
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BEE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.