P2BE7
Hybrid/EV Battery Pack Current Sensor C High
With P2BE7 the signal of current sensor C sits above its usable range, which after conversion would be an impossibly large current. As with P2BE6, the official wording drops the word circuit. No manufacturer documents P2BE7 publicly. GM's coarse-channel check for sensor A (P0AC2) shows typical numbers: above 303 A (ADC count over 4013) during 1.6 s out of every 2 s, Type A, MIL on the first trip. An open sensor ground, a signal touching the supply or an internal sensor fault are common causes. Where three current devices sit on one busbar, as in a Continental patent, the remaining two can still be compared, which helps the controller decide which one is wrong. CARB requires such range checks. Low is P2BE6.
Possible causes
- Open sensor ground high
- Signal wire shorted to the 5 V supply or 12 V medium
- Current sensor C defective medium
Symptoms
- MIL and hybrid or EV warning on
- Battery power limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2BE7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.