P2BE4
Hybrid/EV Battery Pack Current Sensor C Circuit
P2BE4 is the general circuit code for a third current measurement in the high-voltage battery, used where sensor A (P0ABF to P0AC3) and sensor B (P0B0E to P0B13) are already taken. What C measures depends on the design: a further Hall or shunt channel, or a sensor in a second current path; Continental patents a battery busbar with three independent current devices whose values are compared. No manufacturer documents P2BE4 publicly. GM's generic check for sensor A shows the method: before precharge the reading is stored as zero, and if it then moves by less than 1 A once loads draw current, the sensor is judged stuck. CARB requires circuit checks for hybrid inputs. Loss of a current value limits power; bus loss of sensor C is U064C.
Possible causes
- Current sensor C defective high
- Wiring or connector fault between sensor and battery controller medium
- Input stage or software of the battery controller low
Symptoms
- Hybrid or EV system warning
- Reduced electric power or range
- MIL on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2BE4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.