P2BE3
Hybrid/EV Battery Coolant Level Sensor Circuit High
P2BE3 means the level sensor signal of the battery coolant loop is above its valid range, typically from a short to the sensor supply or to 12 V, or from a lost sensor ground. No manufacturer documents P2BE3 publicly. GM's code P1FFD on the Chevrolet Volt shows the same test with numbers: above 4.0 V, 40 of 50 samples at 100 ms, Type A. GM counts an open circuit as high there, so depending on the pull-up design a broken wire can end up under this code rather than P2BE0. GM bulletin PI0961 lists breaks inside the jumper harness of the sensor among the causes. CARB requires such range checks for hybrid inputs. The low side is P2BE2; the reservoir level should be checked before any part is replaced.
Possible causes
- Signal wire shorted to sensor supply or 12 V medium
- Open sensor ground or open signal with pull-up (read as high) high
- Level sensor output stuck high medium
Symptoms
- Hybrid system warning
- MIL on
- Charging possibly disabled
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BE3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.