OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BE1

Hybrid/EV Battery Coolant Level Sensor Range/Performance

P2BE1 reports a battery coolant level signal that lies inside the electrical limits yet makes no sense, such as a value between the defined full and low states or one that flickers while the vehicle stands still. No manufacturer documents this code publicly. GM shows how such a check works on the Chevrolet Volt: its code P1FFB fails when the sensor voltage sits in a forbidden band of 2.85 to 3.11 V, 40 of 50 samples at 100 ms, Type A, while a genuine low level (1.38 to 2.84 V, judged only at standstill) has its own code. GM bulletin PI0961 adds cracked solder joints inside the sensor as a source of intermittent readings. CARB requires rationality checks for hybrid inputs. The pure circuit faults are P2BE0, P2BE2 and P2BE3.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / E1

Possible causes

  • Level sensor with internal fault, e.g. cracked solder joints high
  • Intermittent contact in connector or jumper harness medium
  • Coolant level near the switching point or air in the loop medium
  • Evaluation software in the battery or hybrid controller low

Symptoms

  • Hybrid system warning, often intermittent
  • MIL on
  • Coolant level looks correct at the reservoir

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BE1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication