P2BDE
Motor Electronics Coolant Temperature Sensor C Circuit Low
P2BDE reports that the voltage from coolant temperature sensor C has dropped below its lower limit. Low describes the voltage: for the usual NTC sensor it corresponds to a reading far hotter than the coolant can be, and the cause is mostly a grounded signal wire, a crushed pigtail or a sensor that has shorted internally. No manufacturer documents P2BDE publicly. GM's electronics coolant sensor in the Volt and ELR, monitored as P0CF0, shows typical limits: below 2 % of the 5 V reference (0.1 V) in the 2011 tables and below 4 % (0.2 V) in the 2016 Volt table, 16 of 20 samples at 250 ms, Type B. The open or high case is P2BDF, while the matching low fault of sensor B is P2BDA. Drive power may be limited as a precaution.
Possible causes
- Sensor C signal wire shorted to ground or to the sensor ground high
- Sensor C shorted internally medium
- Crushed or melted sensor pigtail near hot components medium
- Faulty analog input in the evaluating module low
Symptoms
- Hybrid warning or check engine light
- Very high electronics coolant temperature shown in live data on a cold vehicle
- Fan running at full speed shortly after start
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BDE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.