P2BDB
Motor Electronics Coolant Temperature Sensor B Circuit High
P2BDB tells that the signal of coolant temperature sensor B sits above its valid voltage range. With a thermistor fed from a 5 V reference through a pull-up resistor, a broken wire, an unplugged connector or a sensor gone open lets the voltage rise to almost the reference, which the module would read as extreme cold. No manufacturer documents P2BDB publicly. GM's sensor A counterpart on the 2013 Two-Mode hybrid trucks, P0A03, uses a limit of -59.1 °C and the same 30-of-50 count at 100 ms, Type B. Since real overheating would go unseen, controllers usually fall back to a safe pump speed or reduced power. P2BDA covers the grounded case, P2BD8 an unspecified circuit fault of the same sensor.
Possible causes
- Sensor B connector unplugged, not latched or with a backed-out pin high
- Broken signal or ground wire of sensor B medium
- Sensor B thermistor gone open medium
- Signal wire shorted to a voltage source low
Symptoms
- Check engine light or hybrid warning
- Scan tool shows an implausibly low electronics coolant temperature
- Electronics coolant pump running at a fixed high speed
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BDB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.