P2BD8
Motor Electronics Coolant Temperature Sensor B Circuit
Some hybrid and electric drives measure the coolant in the inverter and motor electronics loop at more than one point; J2012 names these sensors A, B and C, and which spot each letter marks is left to the manufacturer. P2BD8 is the general circuit code for sensor B: the signal cannot be used, but none of the specific low, high or plausibility verdicts applies. No manufacturer documents P2BD8 publicly. For sensor A, GM's 2013 Two-Mode hybrid trucks only use the specific codes P0A01 to P0A03, and CARB obliges makers to monitor the electrical inputs used for inverter cooling. Low and high faults of sensor B are P2BDA and P2BDB, plausibility P2BD9. Without a reading the system usually runs the pump harder and may limit power.
Possible causes
- Loose, unplugged or corroded connector at sensor B high
- Damaged signal or reference wire between sensor B and the module medium
- Failed thermistor in sensor B medium
- Faulty input circuit in the controlling module low
Symptoms
- Hybrid or drive system warning, often with the check engine light
- Electronics coolant pump and fan running more than usual
- Possible reduction of electric drive power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BD8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.