P2BD6
Motor Electronics Coolant Pump C Control Circuit High
P2BD6 is stored when the control circuit of motor electronics coolant pump C reads higher than the commanded state allows. A short to battery voltage, or a driver stage that reports overcurrent, are the usual triggers; the pump may then keep running or ignore commands. No manufacturer documents P2BD6 publicly. Ford's 2019 hybrid summary shows how fast the pump A counterpart reacts: P0A07 sets after the output driver has signalled an overcurrent for just 0.25 s, which protects the stage early. GM's Volt and ELR tables fold a short to voltage on their equivalent pump line into P0CE9 (16 failures out of 20 checks spaced 250 ms apart, Type B). Ground faults on pump C are P2BD5, an open line P2BD4. A warning and reduced power follow if cooling suffers.
Possible causes
- Control wire of pump C shorted to a supply wire in the harness high
- Pump C drawing excessive current because of an internal electrical fault medium
- Bent or corroded pins in the pump C connector touching each other medium
- Failed output stage in the controlling module low
Symptoms
- Hybrid system or check engine warning
- Pump C keeps running after the vehicle is switched off, or does not respond at all
- Power limitation during long climbs or fast driving
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BD6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.