OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BD5

Motor Electronics Coolant Pump C Control Circuit Low

P2BD5 flags the command line of the third electric coolant pump in the inverter and motor electronics loop as sitting at too low a level. With a low-side or PWM driver this usually means the wire or the pump input is shorted to ground, so the pump either runs unchecked or not at all. No manufacturer documents P2BD5 publicly. The nearest published logic is Ford's 2019 hybrid summary for pump A: P0A06 is stored once the pump output driver has reported a fault for more than 5 s, with 6 to 19 V on the 12 V system. CARB requires every electronic output of inverter thermal management to be checked for such circuit faults. P2BD4 covers an open line, P2BD6 a short to voltage. If the pump stops, drive power is cut back before the electronics overheat.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / D5

Possible causes

  • Pump C control wire chafed through and touching ground high
  • Water or corrosion in the pump connector bridging the signal pin to ground medium
  • Shorted input stage inside pump C medium
  • Faulty output driver in the controlling module low

Symptoms

  • Warning for the hybrid or drive system, often with the check engine light
  • Pump C runs constantly or stays silent regardless of command
  • Reduced drive power once the electronics warm up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BD5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication