P2BD1
Battery Charging System Negative Contactor B Control Circuit High
P2BD1 flags excess voltage on the coil feed of minus-side charging contactor B, for instance from contact with a 12 V wire or an output stage that will not turn off. The risk is a coil that stays energised and keeps the return pole connected while the module believes it is open, so the module normally blocks charging. No manufacturer documents P2BD1 publicly. For negative contactor A on the Volt and ELR, GM catches this case under P0D11 when the off-state output remains within 0.4 V of supply. On the plus side Audi documents the counterpart P2BCA for the 2024 Q8 e-tron, where over-sensitive software caused the reports. CARB requires charging components to be monitored. Damaged insulation, a wiring mix-up after repair and a faulty output stage are the suspects. P2BD0 is the low case, P2BCC a welded contactor, P0D14 the contactor A twin.
Possible causes
- Control wire of negative contactor B shorted to supply voltage high
- Driver stage stuck on medium
- Over-sensitive diagnostic software low
Symptoms
- Charging blocked
- High-voltage or charging fault warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2BD1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.