P2BCD
Battery Charging System Negative Contactor B Stuck Open
P2BCD is set when negative charging contactor B fails to close, so the charging branch lacks its return path and no current can flow even with the plus side connected. No manufacturer documents P2BCD publicly; Mazda lists the welded minus case P2BCC and the non-closing plus case P2BC6 for the CX-90 PHEV, but not this one. GM's Volt test for positive contactor A (P0D09) illustrates how a non-closing contactor shows up: with the charging and precharge contactors commanded on, the charger-side voltage stays below 10 V, and 8 failures in 9 samples end the check. Under CARB rules the charging hardware of plug-in vehicles must be supervised. Typical causes are burnt or contaminated contacts, a weak coil supply and module software. P2BCC is the welded variant, P2BC6 the plus side, P0D10 the contactor A twin. Charging aborts.
Possible causes
- Negative contactor B burnt or mechanically not closing high
- Coil supply too weak or interrupted medium
- Charging control software misjudging the check low
Symptoms
- Charging stops or never starts
- Charging fault message
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2BCD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.