OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BCA

Battery Charging System Positive Contactor B Control Circuit High

P2BCA means the wire energising the coil of positive charging contactor B shows too much voltage, caused by contact with battery voltage or an output stage stuck in the on state; the contactor could then pull in uncommanded. Audi documents the code as charging contactor 2, short to positive, in the hybrid battery management module (address 008C) of the 2024 Q8 and SQ8 e-tron, including Sportback. Typical case: after AC charging the drive system refuses to come on, with U059B00, P0ADC00 and P0AE000 stored alongside. Audi attributes this to diagnostic software that reacts too sensitively and, in bulletin 2073482 (several revisions), suggests a 20-minute bus sleep before towing. P2BC9 is the low case, P2BD1 the minus side. Here the car may be immobilised.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / CA

Possible causes

  • Over-sensitive diagnostic software (Audi Q8 e-tron) high
  • Control wire of contactor B shorted to supply voltage medium
  • Driver stage does not switch off low

Symptoms

  • Drive system cannot be activated after charging (Audi)
  • Drive system and electrical system fault warnings
  • Charging blocked

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2BCA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication