P2BC9
Battery Charging System Positive Contactor B Control Circuit Low
P2BC9 is the low-signal fault on the coil feed of plus-side charging contactor B: the module measures less voltage on that wire than its command calls for, most often because the wire touches ground or the output stage is being dragged down. With a high-side feed the coil is then starved and the contactor never pulls in, or the output stage trips its own protection. No manufacturer documents P2BC9 publicly. GM notes for its corresponding contactor A test on the Chevrolet Volt (P0D0A) that the open-circuit check cannot detect a short to ground, so this case needs a check of its own. CARB requires monitoring of the charging system on plug-in vehicles. Expect insulation rubbed through on the battery casing or moisture inside a plug. P2BCA is the high counterpart, P2BD0 the same fault on the minus side. That charging mode is then refused.
Possible causes
- Control wire of contactor B shorted to ground high
- Moisture or corrosion in a connector medium
- Coil of contactor B internally shorted low
Symptoms
- Charging session does not start
- Charging fault message
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2BC9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.