P2BC7
Battery Charging System Positive Contactor B Control Circuit/Open
P2BC7 concerns the coil drive line of positive charging contactor B, not its main contacts: the module compares its command with the voltage and current it measures on that line and sets the code when the line is broken or the driver that does not follow. No manufacturer documents P2BC7 publicly. GM's test for the twin code of contactor A (P0D0A) on the Chevrolet Volt shows the method: with the driver off, more than 4 V on the output means an open, and with it on, a coil current under 57 mA counts as open too; the code needs 40 bad readings in a window of 50, taken every 12.5 ms. Monitoring of charging hardware on plug-in models is a CARB requirement. Usual causes: broken wire, loose plug, open coil. Range/performance, low and high are P2BC8–P2BCA, the minus side P2BCE. The charging mode behind contactor B is lost.
Possible causes
- Control wire or connector to contactor B interrupted high
- Coil of positive contactor B open medium
- Driver stage in the control module defective low
Symptoms
- Charging via the contactor B path not possible
- Charging fault indication
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2BC7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.