OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BC6

Battery Charging System Positive Contactor B Stuck Open

P2BC6 means positive charging contactor B does not close when commanded, so the plus side of that charging branch stays dead and the session aborts or never starts. The only maker documenting it publicly is Mazda: on the 2024–2026 CX-90 and 2025–2026 CX-70 plug-in hybrids it reads OBC contactor (+) stuck off, listed with the welded cases P2BC5 and P2BCC. Mazda traces all three to a contact-welding problem in these contactors and fits a new Junction Box No. 2 (bulletin 30-003-26). GM's analogous test for contactor A on the Chevrolet Volt (P0D09) shows the principle: during precharge the voltage on the charger side must build up, and a reading under 10 V ends the check as failed. Welding is P2BC5, the negative side P2BCD. Driving normally continues.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / C6

Possible causes

  • Contactor B damaged inside and no longer closing (Mazda junction box) high
  • Coil supply or drive line interrupted medium
  • Charging control software misjudging the closing check low

Symptoms

  • Charging session stops or does not start
  • Hybrid system malfunction message (Mazda)
  • Driving usually unaffected

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2BC6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication