P2BC1
Charge Air Cooler Coolant Pump A Stuck/Stalled
P2BC1 means the electric pump that circulates coolant through the charge air cooler loop is powered, but its rotor will not turn or stops under load; the pump electronics see high current at little or no speed and report this to the engine module. Audi documents the code as P2BC100 in bulletin 2080825 for 2025–2026 A5/S5 and Q5 models with engine codes DXBA and DXCA: after the car stood unused longer than two months, pump V188 may stick. The MIL and a reduced-power message appear. If the pump runs again on an actuator test and the entry was only intermittent, it is cleared, otherwise the pump is replaced. FCA lists P2BC1-00 on 2018–2019 Alfa Romeo Giulia and Stelvio 2.0 turbos among codes addressed by a software flash. Over- and underspeed of the same pump are P2B83 and P2B84.
Possible causes
- Rotor stuck after a long standstill (Audi bulletin 2080825) high
- Debris, deposits or a worn bearing blocking the impeller medium
- Engine module software needing an update (FCA bulletins for Giulia/Stelvio) low
- Ice in the loop due to insufficient antifreeze low
Symptoms
- Check engine light, often with a reduced-power message
- Hot charge air and less power under load
- No running noise from the pump during an actuator test
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BC1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.