OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BC0

Turbocharger/Supercharger Bypass Valve A Driver Current/Temperature Too High

P2BC0 sets when the output stage that drives bypass valve A reports too much current or overheating. GM applies it to the electric recirculation valve of the LT5-powered 2019 Corvette ZR1: when the H-bridge raises its flag in 80 out of 100 checks spaced 12.5 ms apart, with relay voltage of 11 V or more and no cranking, a Type A fault with immediate MIL results. Integrated H-bridges protect themselves by regulating current, folding it back as the chip warms and finally shutting off – NXP gives a thermal limit of about 175–200 °C junction temperature for its MC33926. Excess current usually comes from a sticking or jammed valve, a shorted motor winding or a short between the motor leads. P2BBF is the low-supply case of the same driver, P00D7 an overheated valve itself. The valve stops responding and boost is reduced.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / C0

Possible causes

  • Sticking or jammed valve making the motor draw high current high
  • Shorted winding in the valve actuator motor medium
  • Motor leads shorted to each other or to ground in the harness medium
  • Overheated or damaged H-bridge driver in the engine module low

Symptoms

  • Check engine light on immediately
  • Reduced boost and less power
  • Compressor surge noise when lifting off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BC0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication