P2BBF
Turbocharger/Supercharger Bypass Valve A Supply Voltage Low
P2BBF concerns the power side of bypass valve A rather than its position feedback. Electric recirculation valves are moved by a small DC motor fed through an H-bridge in the engine module, and the bridge chip itself flags when its supply drops too far. GM documents exactly this for the eCRV of the 2019 Corvette ZR1: the motor driver reports low voltage in 80 of 100 samples at 12.5 ms, with relay voltage at least 11 V and the engine not cranking; Type A, MIL at once. Data sheets for throttle-type H-bridges such as NXP's MC33926 show how such an output stage switches off below its undervoltage lockout and reports this on a status line. Causes are a weak feed, a poor module ground or connector, or an internal driver fault. Without drive power the valve stays where it last stopped.
Possible causes
- High resistance in the engine module feed, fuse or ground connection high
- Weak battery or charging fault causing voltage dips medium
- Corroded pins at the engine module or valve connector medium
- Internal fault of the H-bridge driver in the engine module low
Symptoms
- Check engine light on immediately
- Valve no longer moves, boost limited or surging on lift-off
- Often accompanied by other low-voltage codes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2BBF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.