OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BBE

Turbocharger/Supercharger Bypass Valve A Position Exceeded Learning Limit

P2BBE is not a wiring fault but a failed end-stop learn. GM's 2019 tables for the LT5 Corvette ZR1 describe how the electronic recirculation valve is taught after each engine shutdown: the module first drives it to the closed stop and stores the sensor value, then repeats this for the open stop. If the learned closed value falls outside 85–95 % of the sensor range, or the learned open value outside 10–20 %, the code sets at once (Type A, MIL in one trip). The learn only runs while no position-sensor or valve-circuit fault is active. Typical causes are carbon or oil deposits, a bent flap or shaft, a worn actuator gear or a sensor that has shifted. Since the learn needs a key-off, a repair is only confirmed after a full shutdown. Circuit faults of the same sensor are P2BBB to P2BBD.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / BE

Possible causes

  • Oil or carbon deposits keeping the valve from reaching its stops high
  • Bent flap or shaft, or worn actuator gear medium
  • Position sensor shifted or drifted after a repair or with age medium
  • Non-matching replacement valve with a different travel range low

Symptoms

  • Check engine light after the engine has been switched off and restarted
  • Boost limited or erratic on lift-off

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2BBE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication