OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BBD

Turbocharger/Supercharger Bypass Valve A Position Sensor Circuit High

P2BBD is the high-side counterpart: the position signal from bypass valve A rises toward the full reference voltage. That points to a short to the 5 V supply or to battery voltage, a broken sensor ground – the signal then floats upward – or a defective sensor. On GM's 2019 Corvette ZR1 with the LT5 V8 the module flags a raw position reading above 95 % of reference in 10 out of 14 samples at 100 ms intervals, with at least 11 V on the powertrain relay and outside of cranking; Type A, so the MIL lights at once. P2BBC covers the low side and P2BBB a general circuit fault of the same sensor. With the reading implausible, the module usually holds the valve in a safe position and reduces boost, so the car feels flat and may make noise when the throttle snaps shut.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / BD

Possible causes

  • Open sensor ground wire or corroded ground terminal high
  • Signal wire shorted to the 5 V reference or to battery voltage medium
  • Defective position sensor in the valve actuator medium
  • Moisture in the valve connector creating a leakage path low

Symptoms

  • Check engine light on immediately
  • Reduced power because boost is limited
  • Unusual noise when lifting off the throttle

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BBD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication