OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BBC

Turbocharger/Supercharger Bypass Valve A Position Sensor Circuit Low

P2BBC sets when the position signal of the bypass valve A sensor sits too low – usually an open signal wire, a short to ground or a lost 5 V supply to the sensor. GM uses the code on the 2019 Corvette ZR1 with the supercharged LT5, whose electronic compressor recirculation valve (eCRV) reports its position as a share of the reference voltage: a raw value under 10 % in 10 of 14 samples taken every 100 ms counts as a failure, checked while relay voltage is at least 11 V and the engine is not cranking. It is a Type A fault, so the MIL comes on in the first trip. The opposite case, a signal stuck near the reference, is P2BBD; a valve that does not follow its command is P23AA. Unable to trust the valve position, the module typically limits boost.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / BC

Possible causes

  • Signal wire shorted to ground or chafed against the engine high
  • Open 5 V reference wire or reference shorted by another sensor on the same supply medium
  • Pushed-out or corroded terminal in the valve connector medium
  • Defective position sensor in the valve actuator low

Symptoms

  • Check engine light on in the first trip
  • Limited boost and weaker acceleration
  • Possibly further 5 V reference codes if the supply is shorted

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BBC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication