OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2BA1

Coolant Pump D Underspeed

P2BA1 is set when coolant pump D, a further electric pump in the manufacturer's thermal management, turns slower than its command. No manufacturer documents this code publicly, so which circuit pump D serves and which limits apply is unknown. The same check exists for other letters: Ford's 2024 gasoline summary runs it for pumps A and B as fault type B2 (P2B87, P2B9F), continuously from 11 V, and GM's 2025 tables flag a filtered command-to-feedback gap that persists 8 of 10 seconds. Under CARB 13 CCR 1968.2 (e)(15), outputs must be checked for a correct reaction to their commands. Likely causes are bearing wear, debris at the impeller, low supply voltage or poor contacts. A blocked pump is P2B6A, air P2B6C. Its loop then gets too little flow.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / A1

Possible causes

  • Worn bearing or dragging impeller in pump D high
  • Debris or deposits slowing the impeller medium
  • Low supply voltage or high resistance in power or ground medium
  • Weak motor or drive electronics in the pump low

Symptoms

  • Check engine light or cooling warning, depending on the vehicle
  • Rising temperature of the part cooled by pump D

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2BA1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication