OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B9C

Coolant Pump A Stuck/Stalled

P2B9C signals that coolant pump A is powered and commanded but its rotor does not turn, or stops. Ford uses the code in its 2024 gasoline OBD summary as fault type 71 (actuator stuck) under P2600, where pump A is the auxiliary pump in the high-temperature loop for cabin heating; the check runs continuously above 11 V battery voltage over 5 seconds. Brushless pumps detect a locked rotor themselves, typically from high current without rotation, and report it to the engine computer; the GM patent US20160047374A1 explains how comparing measured current and speed with expected values exposes such faults. Usual reasons are a seized bearing, sludge or debris, frozen coolant or a burnt winding. Pump B has P2B63, pump D P2B6A. A pump that only runs slow sets P2B87.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 9C

Possible causes

  • Seized bearing or rotor in the auxiliary pump high
  • Sludge, sealant residue or debris jamming the impeller medium
  • Coolant frozen in the pump due to weak antifreeze low
  • Burnt motor winding or failed drive electronics low

Symptoms

  • Little or no cabin heat
  • Check engine light
  • Pump silent when it should run

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B9C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication