OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B8E

Intake Air O2 Sensor Heater Control Circuit High Bank 1

With P2B8E, bank 1's intake O2 heater control wire shows more voltage than expected, as when it is shorted to battery voltage or when the driver cannot pull it down. If the module switches the heater on its ground side, such a short means the heater never receives current, the element stays cold and the sensor is never released for measuring. A driver that detects overcurrent may also switch off and report the line high. Ford's patent US9309838B2 shows how strongly the intake sensor relies on a closed-loop heater to hold its set point; without it, EGR control based on intake oxygen is suspended. Bosch's LSU 4.9 data sheet lists the heater pins for checking. No manufacturer documents P2B8E publicly. P2B8D is the low side, P2B8C the performance check.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 8E

Possible causes

  • Heater control wire shorted to battery voltage high
  • Heater with too low resistance tripping the driver's overcurrent protection medium
  • Damaged connector with pins touching each other low
  • Heater output stage in the engine module defective low

Symptoms

  • Check engine light on
  • Intake oxygen sensor stays cold and not ready
  • EGR inactive

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2B8E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication