OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B84

Charge Air Cooler Coolant Pump A Underspeed

P2B84 reports that the electric charge air cooler pump is turning too slowly or not at all, judged by the speed its own electronics send back. GM lists the code next to P2B83 in the 2025 diesel table 25OBDG04B as the low out-of-range case of the pump speed, with the limit printed as a reading below -115 rpm; 8 failed one-second samples out of 10 are needed, with the pump fitted and enabled, relay voltage at 11 V or more and the engine not cranking. Type B, so the MIL comes on after the second faulty trip. Typical reasons are a seized bearing, debris at the impeller, a weak supply or a corroded connector – GM's bulletin 23-NA-102 found water entering the M10 pump plug on the 3.0-litre Duramax. With little flow the intake air runs hot.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 84

Possible causes

  • Worn or seized pump bearing, or debris blocking the impeller high
  • Water or corrosion in the pump connector medium
  • Low supply voltage or poor ground at the pump medium
  • Pump motor or its electronics worn out low

Symptoms

  • Check engine light after the second faulty drive
  • Less power under heavy load or when towing
  • High charge air temperature shown in live data

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B84

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication