P2B83
Charge Air Cooler Coolant Pump A Overspeed/Air In System
P2B83 concerns the electric pump that keeps coolant moving through a water-cooled charge air cooler. When the impeller runs in air instead of liquid, load vanishes and the motor spins up. GM documents this in its 2025 diesel table 25OBDG04B: a reported pump speed of 8,500 rpm or more in 8 of 10 one-second samples sets the code, provided the pump is fitted and enabled, the engine is not cranking and relay voltage is at least 11 V; Type B, MIL after two trips. GM's 3.0-litre Duramax uses such a pump (M10, bulletin 23-NA-102). GM's bulletin 18-NA-291 for the supercharged LT4 notes that this pump switches off once it draws air, so the loop must be vacuum filled. Too little speed is P2B84, the B pump has P2CB1. Hot charge air can cut power.
Possible causes
- Air pocket in the charge air cooler loop after service or a leak high
- Low coolant level in the separate low-temperature loop medium
- Impeller loose or broken on the pump shaft low
- Pump electronics reporting an implausible speed low
Symptoms
- Check engine light after two drives with the fault
- Reduced power under load because the intake air gets hot
- Falling level in the charge air cooler coolant reservoir
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B83
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.