P2B81
Wastegate Position Sensor A Circuit Performance
P2B81 reports that electric wastegate A does not behave as commanded although its sensor signal is electrically fine. GM documents it for the 2.7L L3B (table 19OBDG03D): with the actuator in normal operation the fault counts if the position error exceeds 20 % for over 1 s, actuator current exceeds 1.0 A for over 1 s or duty cycle exceeds 40 % for over 1 s, and 25 of 30 samples must fail; the 2025 table 25OBDG03B tightens the position limit to 10 % for 2 s with 29 of 30. It is Type A, so the MIL comes on in the first trip. GM bulletin PIP6007A names increased friction in the wastegate valve on the 2.0L LSY (Blazer, XT4 to XT6, CT4, CT5, Envision) and calls for turbocharger replacement. Wiring faults set P2AB7 to P2AB9.
Possible causes
- Wastegate valve or linkage binding (GM PIP6007A, turbo replacement) high
- Electric wastegate actuator worn or drawing excessive current medium
- Linkage clip missing or rod detached low
Symptoms
- MIL in the first trip
- Boost too low or too high, flat or jerky acceleration
- Reduced power mode possible
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2B81
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.