P2B80
Turbocharger/Supercharger Boost Control Module B Calibration Not Learned/Programmed
P2B80 is the counterpart of P2B7F for the second boost control module, which only exists where two chargers or two separately driven actuators each carry their own electronics. It is set when module B has no valid calibration or its learn step was never completed. On twin-charger engines a frequent trap is fitting modules or chargers on the wrong side: Melett points out that REA-style actuator calibration belongs to one specific turbocharger and cannot be moved, and Honeywell patent US7689376B2 shows calibration recorded per unit. CARB 13 CCR 1968.2 ties such reprogrammable modules to CAL ID reporting. No manufacturer documents P2B80 publicly. If both codes appear together, a programming or wiring issue in the engine computer is more likely.
Possible causes
- Module B or its charger replaced without programming or learn routine high
- Modules or chargers fitted on the wrong side medium
- Programming session aborted low
Symptoms
- Warning lamp after work on the second charger
- Reduced power because boost on one side is limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2B80
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.