P2B7E
EVAP System Pressure Sensor/Switch C Circuit Intermittent
P2B7E covers a signal from EVAP pressure sensor C that drops out or jumps for brief moments instead of failing for good. No manufacturer documents P2B7E publicly; Audi and VW use only P2B7A and P2B7B, VW also P2B7C and P2B7D, for this sensor. How such a check can work is shown by Mitsubishi's 2023 Outlander PHEV for its tank pressure sensor (P24D9): during the parked leak test it counts how often the signal crosses its own filtered value and sets the code after more than 20 crossings. Loose terminals, a chafed harness near the tank, moisture in the connector or electrical interference – the cause Mercedes-AMG found behind P2B7B – are typical. CARB 13 CCR 1968.2 (e)(15) asks for circuit checks on EVAP inputs. Moving the harness gently while the reading is displayed helps locate the spot.
Possible causes
- Loose or corroded terminal at the sensor connector high
- Harness chafing near the tank or along the underbody medium
- Electrical interference on the signal line medium
- Pressure sensor C with an intermittent internal fault low
Symptoms
- Check engine light comes and goes
- Pressure reading jumps in live data
- Fault often appears only on rough roads or in wet weather
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B7E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.