P2B7D
EVAP System Pressure Sensor/Switch C Circuit High
P2B7D is the high counterpart to P2B7C: the signal of EVAP pressure sensor C sits above its valid range. VW lists it in bulletin 01-26-01 for the 2025–2026 Jetta and Taos FWD, whose fuel tank pressure sensor G400 came with a plug-housing orifice that proved too small; the first step is to check which housing version is installed. Public limits for sensor C do not exist; Mitsubishi's equivalent test on its own tank pressure sensor (P24D8) sets above 4.1 V for 2 s. An open sensor ground, a signal wire shorted to the 5 V reference or to battery voltage and an internal sensor fault all push the signal up. CARB 13 CCR 1968.2 requires out-of-range checks on all EVAP inputs; leak monitoring is held back until repair.
Possible causes
- Sensor ground wire open or high resistance high
- Signal wire shorted to 5 V reference or battery voltage medium
- Early-version sensor assembly (VW Jetta/Taos) medium
- Pressure sensor C failed internally low
Symptoms
- Check engine light on
- EVAP readiness not set after clearing codes
- Car usually drives normally
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B7D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.