P2B7B
EVAP System Pressure Sensor/Switch C Circuit Range/Performance
P2B7B means sensor C delivers a signal that is electrically valid but implausible. Mercedes-AMG documents it as P2B7B26 on the GT63 S E Performance (2024–2026): the ME control unit sees the signal change too slowly, caused by interference on the line, and bulletin LI07.70-P-078293 cures it by twisting the sensor leads that run between the engine computer and the EVAP sensors. Audi's V6/V8 bulletin 2069531 lists P2B7B as pressure sensor 3 implausible, but explains that this entry is mislabelled and the test really belongs to P24D6 on sensor G950. VW's 2025–2026 Jetta and Taos set it together with the narrowed G400 orifice. CARB asks for two-sided rationality checks on inputs where feasible. Leak tests may be suspended meanwhile.
Possible causes
- Interference on untwisted sensor wiring (Mercedes-AMG) high
- Sensor port or orifice too narrow or blocked medium
- Fault entry assigned to the wrong sensor (Audi bulletin 2069531) medium
- Pressure sensor C drifting or sluggish low
Symptoms
- Check engine light on, no driveability complaint
- EVAP readiness monitor not completing
- Code returns after clearing, often after a few drives
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B7B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.