OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B7A

EVAP System Pressure Sensor/Switch C Circuit

P2B7A is the general circuit fault of a third EVAP pressure sensor or switch, C, alongside A (P0450 range) and B (P24D5 range). Each maker assigns the letters itself. Audi V6 and V8 engines (bulletin 2069531, 2022–2025) call it tank ventilation pressure sensor 3, part GX49, and use P2B7A for its electrical fault; the bulletin adds that some control units logged this fault wrongly as P0450. VW uses the code for its fuel tank pressure sensor G400 with NVLD switch on the 2025–2026 Jetta and Taos FWD, where bulletin 01-26-01 blames a too-small orifice in the plug housing. CARB demands that every EVAP input be monitored for circuit faults. Until the fault is fixed, leak tests that rely on this sensor cannot run.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 7A

Possible causes

  • Sensor of an early design (VW G400 with narrow orifice) high
  • Pressure sensor C failed electrically medium
  • Open or short in reference, ground or signal wire medium
  • Control unit logs a wrong fault entry (Audi bulletin 2069531) low

Symptoms

  • Check engine light on
  • EVAP readiness monitor stays incomplete
  • Usually no change in driving behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B7A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication