P2B78
Coolant Heater B Control Circuit High
P2B78 flags the command line of coolant heater B as too high: voltage is present where the commanding module expects a low level, or its driver reports overcurrent. A short to a 12 V circuit is the classic cause; with a low-side driver, a heater input that has failed short can produce it as well. The risk is a stage that will not switch off on request, which is why heater designs such as US11628706B2 include independent overheat sensing in the housing. No manufacturer documents P2B78 publicly. The CARB regulation calls for an electrical check of such a line. If the fault lies in a shared harness, P2B74 for heater A may appear at the same time; measuring the request lines with the heater unplugged separates harness faults from heater faults.
Possible causes
- Request wire for heater B shorted to a 12 V circuit high
- Heater B input failed short inside the heater medium
- Damage in a harness section shared with heater A low
Symptoms
- Heater stage B off, or running although not requested
- Unusual battery drain while parked
- Lower heating power in winter
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B78
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.