P2B75
Coolant Heater A Control Circuit Performance
P2B75 is set when the command circuit of coolant heater A tests electrically sound but the heater's response does not match the request – the coolant leaving it fails to warm, for instance, or reported power or current stays off target. CARB 13 CCR 1968.2 (e)(15.2.2) asks for this kind of functional check on output components. GM's bulletin PIC5943 for the 2013–2014 Volt shows the practical test: with full heat requested in electric mode the heater core temperature should climb to about 54 °C and hold; if not, early coolant heater control modules were replaced (GM stores B101D there, not P2B75). No manufacturer documents P2B75 itself. Air in the loop, weak circulation, a failed element or faulty heater electronics are typical causes.
Possible causes
- Air trapped in the heater loop or low coolant level high
- Heating element weak or partly failed medium
- Internal fault in the heater control electronics medium
- Coolant pump or valve in the heater loop not circulating enough low
Symptoms
- Cabin warms slowly or only with the engine running
- Heater core temperature in live data stays low despite full heat request
- Electric range reduced in winter because the engine starts for heat
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2B75
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.