P2B72
Coolant Heater A Control Circuit/Open
P2B72 says the command line to coolant heater A is open or has lost continuity. Keep it apart from the engine coolant heater family P01E8–P01EF: the other J2012 codes for this heater – internal module, supply voltage and over-temperature under P2DA4–P2DA7, lost communication under U069E – point to a unit with its own electronics, such as the electric coolant heater of hybrids and EVs. GM's 2013–2014 Volt used a separate coolant heater control module for this job (bulletin PIC5943, no cabin heat in electric mode). No manufacturer documents P2B72 publicly, so limits and timing are unknown. CARB 13 CCR 1968.2 requires circuit monitoring of commanded outputs. In winter the cabin stays cold, or an engine runs more often to supply heat.
Possible causes
- Command wire to the heater broken or connector not latched high
- Terminal pushed back or corroded in the heater connector medium
- Input stage of the heater electronics open internally medium
- Output stage in the commanding control module faulty low
Symptoms
- Little or no cabin heat, especially in electric driving
- Engine starts more often in cold weather to provide heat (hybrids)
- Warning or fault message, depending on the manufacturer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B72
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.