OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B68

Coolant Pump D Control Circuit High

P2B68 flags a control line for coolant pump D that reads too high: it touches a voltage source or is pulled up while the driver should switch it. No manufacturer documents the code publicly. In Ford's 2024 summary the matching pump A and B codes (P2603, P261D) rest on the same principle, with the smart driver in the engine computer reporting an output circuit fault during a continuous check above 11 V. Likely causes are a wire rubbed through onto a battery-fed conductor, moisture bridging pins or a fault inside the pump electronics. With a line stuck high the pump may run at a fixed speed or ignore commands. Section (e)(15) of CARB 13 CCR 1968.2 wants this kept apart from the open and low faults. Open circuit is P2B66, ground short P2B67, pump E uses P2DF6.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 68

Possible causes

  • Control wire shorted to a battery or ignition feed high
  • Moisture bridging pins in the connector medium
  • Fault in the pump electronics pulls the line up low

Symptoms

  • Warning lamp with stored code
  • Pump D runs at a fixed speed or ignores commands

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B68

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication