P2B67
Coolant Pump D Control Circuit Low
P2B67 means the control line of coolant pump D sits too low, typically because it is shorted to ground or the driver stage sees excess current. No manufacturer publishes this code. Ford's comparable entries for pumps A and B (P2602, P261C) set when the smart driver in the engine computer reports an output fault, checked continuously above 11 V. Chafed insulation against body or engine, water in the connector and an internally shorted pump input are the usual suspects. Depending on how the output is wired, a ground short can leave the pump running nonstop or silence it completely. With the pump unplugged, measure the resistance of the signal wire to ground before replacing parts. Open circuit is P2B66, short to voltage P2B68; pump C has P26F5.
Possible causes
- Control wire chafed through and shorted to ground high
- Moisture or corrosion in the pump connector medium
- Control input inside the pump shorted low
Symptoms
- Warning lamp with stored code
- Pump D runs constantly or not at all
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B67
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.