P2B66
Coolant Pump D Control Circuit/Open
P2B66 is the open-circuit code for the control line of coolant pump D, the pump a manufacturer labels D in its thermal management. The driver stage in the engine computer detects a broken wire, an unplugged connector or a pump input that no longer draws current. No manufacturer documents this exact code publicly. Ford's 2024 summary shows the analogous logic for pumps A and B (P2600, P261A): a continuous check from 11 V battery voltage, in which the smart driver reports the output fault. Under CARB 13 CCR 1968.2 (e)(15), output components must be watched for circuit faults. A short to ground is P2B67, a short to voltage P2B68; pumps C and E use P26F4 and P2DF4. Without control the pump stays off and its loop loses cooling.
Possible causes
- Pump connector loose, corroded or unplugged high
- Control wire broken between engine computer and pump medium
- Control input inside the pump open low
Symptoms
- Warning lamp with stored code
- Pump D does not respond to commands
- Higher temperature in the loop served by pump D
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B66
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.